DuPont — Specification review requests
Specification review requests: prepare the evidence needed for a fiber or protective textile decision.
Ask a material question- Brief
- Sample
- Approval
- Order context
Service request ledger
| Request | Include |
|---|---|
| Sample discussion | Start a sample discussion with the material reference and the question the specimen should answer. For a fiber or yarn, describe fiber composition, linear density, twist where relevant and the intended processing route. For a fabric, include weave construction, GSM, usable width and finish. Attach the reference identifier in the message so a later comparison can distinguish the original sample from a revised construction. A photograph may establish appearance, while a physical specimen is needed to judge handle and construction detail. |
| Specification question | A specification question needs separate fields for the buyer target and the available material evidence. Write the desired property, unit and acceptance rule as a requirement. Record any reported result with its test method, specimen state and report reference. When reviewing tear strength or tensile strength, identify the tested direction. When reviewing heat or flame behaviour, describe the exposure, conditioning and sample assembly. The material name alone cannot supply the missing test conditions or establish protection for an end use. |
| Availability question | Availability inquiries work best with a clear format and quantity basis. A cone, package, roll or cut length is relevant only to the material being requested. Include the destination and requested timing as questions for confirmation. Stock selection may reduce the development steps if the exact lot and specification are acceptable. A custom route allows a different construction target but needs a defined sample revision, test review and approval gate. Keep these routes distinct when planning a trial. |
| Order context | Use the next decision column as a practical handoff: identify who will evaluate the sample, which documents they need and what would prevent approval. Abrasion resistance and flexibility may pull the brief in different directions; a surface wear result does not replace a handle review. Note care conditions and dimensional stability expectations before a trial is agreed. Preserve the dated specimen reference and the written acceptance criteria together, so changes in composition, finishing or usable width trigger an intentional review rather than an assumption of equivalence. |
Prepare the next handoff
Share the sample reference and order context.